![what is windows xp service pack 1 2 3 what is windows xp service pack 1 2 3](https://intensiveing.weebly.com/uploads/1/2/3/9/123946703/336137334.png)
- #What is windows xp service pack 1 2 3 install
- #What is windows xp service pack 1 2 3 update
- #What is windows xp service pack 1 2 3 free
#What is windows xp service pack 1 2 3 install
I find the fact that SP3 can’t create an uninstall routine that will work five hours after the install without the system having been altered incredible – not to mention the fact that it causes USB ports to malfunction.
#What is windows xp service pack 1 2 3 free
Not only that, but XP destroyed the restore point I created just before installation (and not becasue of low disk space I have over 20 GB free on the drive) and the restore points XP created did not work.
![what is windows xp service pack 1 2 3 what is windows xp service pack 1 2 3](https://images.sftcdn.net/images/t_app-cover-l,f_auto/p/44843ec2-96d0-11e6-b9a6-00163ec9f5fa/3463041209/windows-xp-service-pack-3-screenshot.png)
And the uninstall routine failed despite the fact that ran it the same day I installed it, without having touched any file or folder. In my case, it replaced occasional annoying USB error messages with USB ports that didn’t work at all. Microsoft Support’s instructions are very similar – in fact they seem to have copied Naushad Unni’s instructions (his predate theirs), but they seem to have tacked on the part about going back and re-trying one of the first three methods, resulting in a garbled procedure whereas his is clear. In searching around, I found this – (scroll down to “To Remove SP3 from Recovery Console” by Naushad Unni). We can conclude that Method 3 (Recovery Console) works to some extent, but that the instructions are garbled. Yet System Info says I’m still running SP3. So I suspect that SP3 was at least partially uninstalled. Out of curiosity, I tried using the front USB ports again and they worked. Now, this is the error I was getting under SP2 and that SP3 was supposed to cure. While searching around for a solution, I got a “this device could run faster on a USB 2.0 port” error. But when I ran spuninst.exe again as instructed in Point 10 I got the same results – “couldn’t find the file specified” and “SP3 was not uninstalled.” This executed back to a command prompt and I followed the rest of the instructions. Then I tried Method 4, using the Recovery Console (running spuninst.txt as a batch file). In any case, neither of them worked – I got a “System was not restored” message. Only two restore were points available, dating from just before the installation, but they referred not to SP3 but to two security updates I don’t even remember installing. I had taken care to create a restore point manually just before installing, but found it had disappeared. I looked here – – and tried to roll back to a restore point as suggested in Method 3, since I had tried the first two methods (which in fact are the same – both run spunist.exe). I tried to uninstall it (about five hours later) and got the “couldn’t find the file specified” and “SP3 was not uninstalled” error messages mentioned above. I installed SP3 and the USB ports on the front of my computer stopped working.
![what is windows xp service pack 1 2 3 what is windows xp service pack 1 2 3](https://joanesmarti.com/wp-content/uploads/2014/08/xp-4-abril-300x128.png)
Follow the instructions in the upcoming wizard and remove sp3 from by restoring to the point created at the time of installation of service pack 3 for windows XP. Click the date on or before which you had installed windows XP service pack 3 and then click Installed Window XP Service Pack 3 and the restore point boxĥ. Click Restore My Computer To An Earlier Time and then click nextĤ. This will start up the system restore to restore your computer to an earlier time and click Nextģ. Open Start Menu > Run, type “ %systemroot%\System32\restore\rstrui.exe” and press EnterĢ. Note: Make sure you have restarted your computer at least once after installing windows service pack 3 only then you can use system restore to uninstall service pack 3ġ. Method 3: Remove SP3 with Default system restore Follow the instructions on the screen to remove windows service pack 3 This will start the windows XP service pack 3 removal wizard and click Nextģ. Open Start Menu > Run, type c:\windows\$NtServicePackUninstall$\spuninst\spuninst.exe and press EnterĢ. Method 2: Remove SP3 with the hidden $NtServicePackUninstall$ folderġ. click Finish after complete removal and to restart your computer Locate Windows XP Service Pack 3 and click removeĤ. Click to select the show updates check boxģ. Open Start Menu > Run, type appwiz.cpl and press EnterĢ. Method 1: Remove SP3 from add / remove programsġ. These are the methods to remove / delete / uninstall XP service pack 3 or SP 3 Lets discuss all these methods to remove Windows XP service pack 3 or Windows XP SP3 Once you have Windows XP service pack 3 installed there can be more than one method to remove it. We had already got some mails from readers who want a working step by step procedure to remove or uninstall Windows XP service pack 3 or SP3 from their computers. In that case you would need to uninstall Windows XP SP3 from your computer.
#What is windows xp service pack 1 2 3 update
Windows XP Service Pack 3 (SP3) is one the most important update for Windows XP, but it may happen that after installing Windows XP service pack 3 some of the hardware devices may not work properly.